System Setting - Mitsubishi CP710E Operation Manual

7. Setting the functions (Memory SW menu)
V POSITION
Function Adjusting the vertical position of printing image.
Setting area - 28 to +28 ( Change each 2 lines)
When 2-image printing ( selected "2" in IMAGES) on L size print paper, the top and bottom of the image
may not be fully printed depending on memory size. It may be necessary to adjust part of the image in
the UP, DOWN, RIGHT or LEFT direction.
V POSITION function is to adjust the position for UP and DOWN direction of the memorized image and
to print it correctly.
This function is available only when printing 2 multi-image on L size paper and selecting "2" in
"IMAGES".
WIDE SET
Function Enlarging print possible area.
NML
EXTRA ................ Enlarging the print area
The top or bottom of the image cannot be printed depending on the input signal. In this case, select
"EXTRA".
When "EXTRA" is selected, comments are not printed.
4 4 4 4 4

SYSTEM SETTING

INT MENU ( Initial menu)
All settings of 3 memory programs to store each function are initialized.
MAIN ................ The memorized settings in MAIN MENU are initialized.
MEM.SW .......... The memorized settings in MEMORY SW MENU are initialized.
Select MAIN or MEM.SW to initialize the settings. When INITIALIZE is set to "GO", initializing is carried
out.
INITIALIZE (Initializing )
Function Initializes the menu selected in "INIT MENU".
GO
OFF ................ Initializing is not carried out.
Normally, this menu is set to OFF. When GO is selected, initializing is carried out and returns to OFF
after initializing.
REMAINING
Function Inform the number of remaining paper by a buzzer tone.
OFF ...................This function is not available.
0 .....................The buzzer sounds five times as the point you set after printing.
Please observe the following precautions when you use this function.
• If a paper jam occurs, the remaining paper may not be informed correctly.
• Do not change the ink sheet size S to L ( or L to S) in the middle of using ink sheet.
• Make sure to replace the print paper and ink sheet at the same time.
• Make sure to use the new one when you set the ink sheet and print paper.
• Do not feed the print paper after you set the print paper.
................ Normal print
System setting 2
................ Initializing is carried out.
The setting area is 0 to 10.
The buzzer sounds five times after every printing and the active signal in BUSY 2 will
also be output.
47