Table of Contents
Advertisement
CAUTION ON RELOCATING
When transporting this unit, make sure it is not likely to be subjected to impacts. They can be a prime cause for damage. Further, make sure to
disconnect the power cord from the power outlet, and the cables from the connected devices.
Periods:
According to the recommendations of the manufacturer of medical device.
Scope: a)
Visual inspection
Housing, leads, controls, displays, labels/ markings, accessories, operation manual.
b)
Funcitonslity test
Testing of functions (according to operation manual) as well as compatibility and usability of device and accessories.
c)
Electrical test
Testing of electrical safety of the system according to EN60601-1.
High humidity or dust
Avoid locations with high humidity and dust in order to avoid malfunctioning of the device.
Also avoid locations subject to corrosive gasses and smoke.
Heat
Direct sunlight, heaters or other heat sources may deform the housing and subsequently cause malfunctioning.
The supplier will make available on request such circuit diagrams, component part lists, descriptions, calibration instructions or other information
which will assist the USER's appropriately qualified technical personnel to repair those parts of the EQUIPMENT which are classified by the
manufacturer as repairable.
The use of ACCESSORY equipment not complying with the equivalent safety requirements of this equipment may lead to a reduced level of
safety of the resulting system. Consideration relating to the choice shall include:
- use of the accessory in the PATIENT VICINITY
- evidence that the safety certification of the ACCESSORY has been performed in accordance to the appropriate EN60601-1 and/or EN60601-1-
1 harmonized national standard.
The transportation and storage environmental conditions are:
Temperature : -20 C - +60 C (-4 F - +140 F)
Humidity : 90%RH or less at 40 C(104 F)
Note : The above transportation environmental conditions indicate the storage environmental conditions during transport.
Dust or other foreign matter adhering to the print paper or the sheet cartridge, or deformation resulting from exposure to extremely low or high
temperatures could cause loss of colour, uneven colour or lines, or wrinkles in the print images.
If there is noise or vibration in the VCR still-image or playback picture, the print image may be distorted or the upper part may be crooked.
NOTE:
YOUR UNDERSTANDING IS REQUESTED FOR THE LOSS OF IMAGES IN MEMORY DUE TO THE SUDDEN OCCURRENCE OF A
MALFUNCTION.
As for paper sheet set, refer to page 5 "Installing print paper and ink sheet".
This product is to be employed with medical equipment, just for reference
purpose, not for medical diagnostic purpose.
SAFETY CHECKS
TECHNICAL DESCRIPTION
OTHER CAUTIONS
2. Precautions
3
Advertisement
Table of Contents
