Table of Contents
Advertisement
8. Printing procedures (Special prints)
External remote 1 or 2 terminals on the rear panel
The images can be stored in memory and printed by sending the remote signal through the external
remote terminal on the rear panel. When "MEM & PRINT" function is set to "ON", the images can be
printed after storing.
• Switching High/Low of BUSY signal and defining BUSY signal can be done in "2.REMOTE SET" in MEMORY SW MENU.
• Make out the necessary circuit to use this function by referring to the following.
External REMOTE 1 terminal
Circuit in the unit and Pin No.
2
External remote terminal Signal allocation Connector REMOTE 1
Pin No.
Function
1
Ground
2
MEMORY
3
BUSY
• When memorizing image through MEMORY terminal, use TTL level of 74LS series or mechanical switch.
• When the signal from BUSY terminal is received with TTL level, keep the following.
| 1
| =2mA or less, |1
OL
|1
| shows the current flowing into the unit at Low output, | 1
OL
output.
64
3
1
Transmission/
Destination
-
Earth
VCP
Memory: When the signal becomes "LOW" from "HIGH", the image is stored
in memory. (When the signal has been "LOW" for 60msec. or more, the
image is stored in memory. )
PC
When "REMOTE BUSY" is set to "HIGH":
" HIGH " : The VCP cannot accept the MEMORY signal.
" LOW " : The VCP can accept the MEMORY signal.
When "BUSY LEVEL" in Memory SW Menu is set to "LOW", the setting of
"HIGH" and "LOW" becomes inverse. Refer to page 45.
BUSY signal can be defined with BUSY 1 and BUSY 2, too. This terminal
functions according to only BUSY 1 definition.
| =1mA or less
OH
Plug Pin No.
2
3
1
Description
| shows the current flowing out of the unit at High
OH
Advertisement
Table of Contents
