Table of Contents
Advertisement
8. Printing procedures (Special prints)
Setting 1-image/multi-image memory
When memorizing 1 image in STROBE mode
This setting is used to memorize 1 image in FRAME, FIELD A or FIELD B.
1 Set the mode to 1-image.
Select "OFF" in "MULTI : OFF" in "3. ADDITIONAL".
2 Set the page increment function to ON.
Set the "PAGE INC" to ON in "6. SYSTEM". (The initial setting is "ON".)
• In FIELD mode, the image is memorized in the stored in memory page in order of page [A]
• To memorize images in page [A] and [B] only once, (not memorizing images repeatedly) set "MEM&STOP" to "ON" in "1.
KEY SET" from MEMORY SW MENU.
• When "PAGE INC" is set to OFF, images are memorized in page [A] repeatedly.
When memorizing multi- image (2, 4 or 16 images) in STROBE mode
This setting is used to memorize multi-image in order in one memory page.
1 Set the mode to MULTI.
Select "ON" in "MULTI " in "3. ADDITIONAL".
2 Set the number of images and print size.
Set "MODE : SAME/DIFF/PHOTO" and "IMAGES : 2/4/16" in "3. ADDITIONAL".
• Refer to 1 MULTI PRINT for setting the number of multi-image.
• When "DIFF" is selected in "MODE" and 2, 4 or 16 is selected in "IMAGES", 2, 4 or 16 images are stored in memory
in order at the set interval.
When the images are fully stored in memory page, the strobe memorization stops.
• When "MODE" is set to "SAME" or "PHOTO", the memorization status is as same as one image memorization.
Displaying the source image (image from the input signal) or the memorized image
SET
1 Press the SET
• " CHANGE : OK/CANCEL " is selected.
• When changing the setting, select "CANCEL" and press the SET
SET
2 Press the SET
• The MAIN MENU is displayed.
60
button.
button.
SET
button.
page [B]
page [A]....
Advertisement
Table of Contents
