Setting The 2F-Dq535 Card Hardware - Mitsubishi 2F-DQ535 Instruction Manual

6 Hardware Settings
(6) Mount the card handle. Fit the handle so that the network connector of the module board fits into the
hole on the card handle plate.
(7) Fasten the card and card handle with screws. This completes the module mounting process. Tighten
the screws with a cross-point driver.
Fix screw

6.2. Setting the 2F-DQ535 Card Hardware

The 2F-DQ535 card does not have any hardware settings.
All settings are completed with the master station parameters and robot controller parameters.
Refer to "8.1 Setting the Parameters" for details.
6-22 Setting the 2F-DQ535 Card Hardware
Fix screw