Mitsubishi CP710E Operation Manual page 71

9. Troubleshooting
Symptom
The stored image in the memory cannot be
enlarged to fill the maximum print area.
The color or picture quality is different between
the memorized image and the printed image.
The image on the monitor screen printed paper
is not colored correctly.
(When the VIDEO signal without color burst
signal is inputted to the unit, the image on the
monitor screen or printed image becomes
monochrome or rainbow-like colored image.)
The set comments do not appear on the print
paper.
Wired remote control cannot be operated.
The image cannot be printed on pre-cut sheet
correctly.
70
Check and Remedy
Is the SMALL size ink-sheet installed when selecting "S" in "MODE :
S/L"?
Or is the LARGE size ink-sheet installed when selecting "L" in
"MODE : S/L"?
Check the current setting. Refer to page 35.
Is the paper size set to "N" in the size setting in SYSTEM menu?
Set the size to "M" or "W". Refer to page 37.
Is the S size image printed on the L size paper?
Check the current setting. Refer to page 35.
Is the print area set correctly in the USER SIZE ADJ?
Check the setting of the print area. Refer to page 38.
Is the color of the image stored in the memory adjusted?
Adjust the color of the image stored in the memory with the image
adjustment display (COLOR ADJ). Refer to pages 31-32.
Is the DCF set to "OFF"?
Set the DCF to "OFF". Refer to page 33.
Is the COMMENT set to "OFF"?
Set the COMMENT to "ON". Refer to page 36.
Is the COMMENT inputted?
Input the COMMENT on the menu. Refer to pages 39-42.
Is WIDE SET in 3.PRINT SETTING in MEMORY SW MENU set to
EXTRA?
Set WIDE SET to EXTRA. Refer to page 47.
Is the plug of the remote control disconnected from its terminal on
the unit?
Connect the plug of the remote control to the REMOTE terminal on
the front of the unit.
The supplied remote control cannot be used with the terminals on
the rear panel.
Is the wired remote control for this unit (accessory) used?
Use the remote control for this unit.
Is the mode set for printing on pre-cut sheet?
Refer to pages 56-57. Printing on pre-cut sheet is not available on
L-size paper.
Is the printing location correct?
If the printing location does not fit to the pre-cut sheet, re-install the
sheet.(Refer to pages 7-8 "Installing print paper and ink sheet".)