Table of Contents
Advertisement
Displaying the source image (image from the input signal) or the memorized image
SET
1 Press the SET
button.
• " CHANGE : OK/CANCEL " is selected.
• When changing the setting, select "CANCEL" and press the SET
SET
2 Press the SET
button.
• The MAIN MENU is displayed.
SET
3 Press the SET
button.
• "SAVE 1/2/3" is selected.
• This menu is used to store the setting in any one of 3 programs (1, 2 or 3).
4 Press the RIGHT or LEFT shift button to select the program number 1, 2 or 3 to store the setting.
• The setting will be overlaid. When keeping the stored program, do not select the program No. in which the setting is
stored.
SET
5 Press the SET
button.
• The source image (image from the input signal) or memorized image is displayed.
Pressing the MEMORY button
1 Display the desired image for the automatic interval printing on the monitor.
2 Press the MEMORY button.
• The set automatic interval printing starts.
Interrupting automatic interval prints
• When the STOP button on the remote control is pressed, the automatic interval print is interrupted.
Note :
• "MEM&STOP" and "MEM&PRINT" function after the last image of the multi-image is stored in memory.
• Even if the number of prints is set to more than 1 at strobe print, STROBE is applied to the first page only.
8. Printing procedures (Special prints)
SET
button.
63
Advertisement
Table of Contents
