Using The Initial Value Pattern - JUKI LBH-1790A Series Instruction Manual

10. Using the initial value pattern

This sewing machine has the initial value to perform the optimum sewing for the sewing shapes (31 shapes).
→ Refer to "XI. INITIAL VALUE DATA FOR EACH SHAPE TABLE" p.76.
When creating sewing data newly, it is convenient to create it by copying the initial value pattern.
1) Set the mode to the input mode.
Under the input mode where SET READY LED 
goes out, pattern change is enabled. If the current
mode is the sewing mode, press READY key ❷
to change over the mode to the input
mode.
2) Call initial value pattern.
The currently-selected pattern No. A is displayed.
Press DATA CHANGE key ❼
initial value pattern
3) Select shape.
The shape selection screen B is displayed to
shown the currently-selected shape C.
Select shape C to sew with DATA CHANGE key
❼
. It is possible to select the shape from
among 12 shapes at the time of your purchase.
However, it is possible to select the shape from
among maximum 31 shapes by increasing the
shape selection level (K004).
→ Refer to
"V-21. Method of changing memory
switch data" p.51.
4) Perform trial sewing.
Press READY key ❷
the sewing mode. Then it is possible to perform
sewing and the selected shape can be sewn.
* Initial value pattern can edit the needle thread
tension data only. However, it returns to the
initial value when changing the shape or
performing re-call of the pattern. So, be careful.
5) Copy initial value pattern.
Copy the pattern which has been selected and
confirmed through the steps above to the normal
pattern and use it.
Copying procedure → Refer to
sewing pattern" p.39.
to select
.
to set the mode to
"V-14. Copying
A
 ❷
– 30 –
2)
B
3)
C
❼