Table of Contents
Advertisement
2 Return the presser.
Press ONE STITCH RETURN button
and the presser returns stitch by stitch.
Press ONE STITCH FEED button
the presser advances stitch by stitch. Return the
presser to the re-sewing position.
3 Start sewing again.
When the SEWING MACHINE START button
(L) is pressed, sewing starts again.
＊ For the setting procedure of the start switch, refer
2-17. Changing memory switch
to
2-4-2. To perform sewing from the start
1 Release the error.
Press RESET button
error, Then the step motion screen is displayed.
2 Return the sewing product to the setting
position.
Press INITIAL POSITION TRAVEL button,
(E) and the presser returns to the sewing product
setting position (start position).
Press CANCEL button
up and the presser returns to the sewing product
setting position (start position).
3 Start the sewing.
When the SEWING MACHINE START button
(L) is pressed, sewing starts again.
＊ In case of the continuous stitching, (E) moves
to the sewing start position of the shape during
sewing and when it is pressed subsequently, it
moves to the sewing start position of the previous
shape.
(D),
(E), and
data,p.78.
(B) to release the
(I) to close the pop-
− 0 −
L
G
H
＊ The existing sewing commands are shown
in reverse video in section (G). The kinds of
commands are kinds below.
: Sewing command
: Thread trimming command
: Thread trimming command
: Thread tension
: Knife drive
＊ The existing number of stitches/number of total
stitches are displayed in section (H).
＊ Thread tension value is displayed in section (I).
When thread tension command is inputted in the
needle entry point by means of the external input
device, the button is displayed and thread tension
can be changed.
＊ Knife can be cancelled with (K).
K
J
I
E
F
D
Advertisement
Table of Contents
