JUKI IP-310/ACF-172-1790 Instruction Manual page 124

Error
code
E02
E03
E0
E0
E0
E0
E0
E10
Description of error
Overcurrent of main shaft motor
When current flows excessively to sewing machine
motor.
Abnormality of stepping motor power
When stepping motor power of servo control p.c.b.
fluctuates ±1% or more.
Abnormality of solenoid power
When solenoid power of servo control p.c.b. fluctuates
± 1% or more.
Abnormality of temperature of heat sink for servo
control p.c.b.
When temperature of heat sink of servo control p.c.b.
is °C or more.
Zigzag width motor origin retrieval error
When origin sensor signal is not inputted at the time of
origin retrieval motion.
Y-feed motor origin retrieval error
When origin sensor signal is not inputted at the time of
origin retrieval motion.
Needle thread trimmer motor origin retrieval error
When origin sensor signal is not inputted at the time of
origin retrieval motion.
Presser motor origin retrieval error
When origin sensor signal is not inputted at the time of
origin retrieval motion.
− 123 −
How to Place of
recover recovery
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.