Date; Default Configuration; Display Fruid; Disconnect Remote Or Lan Console - HP Integrity rx4640 Operation And Maintenance Manual

This command allows the local or remote port user to connect over the MP LAN to another MP on the network. The user that
launches the command is given a private connection to the other MP over the LAN. To return to the original MP, type
to disconnect the CSP session.

Date

DATE: Displays the current date, as generated in the MP real-time clock.

Default Configuration

DC: Default Configuration—reset all MP parameters to the default configuration
This command sets all MP parameters back to their default values. The user may reset all or a subset of the following
parameters:
• IP configurations
• Modem configuration
• Paging configuration
• Command Interface configuration
• Disable remote access, security configuration
• Session configuration. For example: setting the security configuration to default erases all users and passwords.
There are three ways to reset passwords in the MP:
1. In the SO command, change individual users.
2. In the DC command choose "Reset Security Configuration".
3. Forgotten passwords can be reset by pressing the reset button on the back panel of your HP Server. See Figure 2-7 on
page 22. After the MP reboots, the local console terminal displays a message for five seconds. Responding to this message
in time will allow a local user to reset the passwords.
Notice that all user information (logins, passwords, and so on) is erased in methods 2 and 3.

Display FRUID

DF: Display FRUID information
This command displays FRUID information from the BMC for FRU devices. Information provided includes serial number;
part number; model designation; name and version number; and manufacturer.

Disconnect Remote or LAN Console

DI: DIsconnect remote/modem or LAN/WEB console
This command disconnects (hang up) the remote/modem or LAN/WEB users from MP. It does not disable the ports. The
remote console is no longer mirrored.

Front Panel Process

FP: Turn off front panel fault or attention LEDs
This command allows the user to control the state of front panel fault and attention LEDs, individually or together.
Chapter 5
Management Processor Command Interface
Utilities
CTRL+]
113