Dual Serial Controller; Field Programmable Gate Array - HP Integrity rx1620 Operation Manual

System Information
System Board
• Non-volatile memory
• Scratch RAM
• Real Time Clock
• UARTs
• External Registers
• Firmware read/writable registers
• Two general purpose 32-bit registers
• Semaphore registers
• Monarch selection registers
• Test and Reset register
• Reset and INIT generation

Dual Serial Controller

The dual serial controller is a dual universal asynchronous receiver and transmitter (DUART). This chip
provides enhanced UART functions with 16-byte FIFOs, a modem control interface. Registers on this chip
provide onboard error indications and operation status. An internal loopback capability provides onboard
diagnostics.
Features include:
• Data rates up to 115.2kbps
• 16550A fully compatible controller
• A 16-byte transmit FIFO to reduce the bandwidth requirement of the external CPU
• A 16-byte receive FIFO with four selectable interrupt trigger levels and error flags to reduce the
bandwidth requirement of the external CPU
• UART control that provides independent transmit and receive
• Modem control signals (-CTS, -RTS, -DSR, -DTR, -RI, -CD, and software controllable line break)
• Programmable character lengths (5, 6, 7, 8) with Even, Odd or No Parity
• A status report register

Field Programmable Gate Array

The field programmable gate array (FPGA) provides ACPI and low pin count (LPC) support for HP Intel
Itanium 2 platforms based on HP chipsets. This controller is connected to the PDH bus and provides these
features:
• ACPI 2.0 interface
• LPC bus interface to support BMC
• Decoding logic for PDH devices
128
Appendix B