Processor Dependent Hardware Controller; Dual Serial Controller; Field Programmable Gate Array - HP Integrity rx2620 User's & Service Manual

Introduction
System Board Components

Processor Dependent Hardware Controller

The PDH controller provides these features:
• 16-bit PDH bus with reserved address space for
— Flash memory
— Non-volatile memory
— Scratch RAM
— Real Time Clock
— UARTs
— External Registers
— Firmware read/writable registers
— Two general purpose 32-bit registers
— Semaphore registers
— Monarch selection registers
— Test and Reset register
• Reset and INIT generation

Dual Serial Controller

The dual serial controller is a dual universal asynchronous receiver and transmitter (DUART). This chip
provides enhanced UART functions with 16-byte first-in, first-out (FIFO), a modem control interface.
Registers on this chip provide onboard error indications and operation status. An internal loopback capability
provides onboard diagnostics.
Features include:
• Data rates up to 115.2 kbps
• 16550A fully compatible controller
• A 16-byte transmit FIFO to reduce the bandwidth requirement of the external CPU
• A 16-byte receive FIFO with four selectable interrupt trigger levels and error flags to reduce the
bandwidth requirement of the external CPU
• UART control that provides independent transmit and receive
• Modem control signals (-CTS, -RTS, -DSR, -DTR, -RI, -CD, and software controllable line break)
• Programmable character lengths (5, 6, 7, 8) with Even, Odd or No Parity
• A status report register

Field Programmable Gate Array

The field programmable gate array (FPGA) provides ACPI and LPC support for the PDH bus and provides
these features:
• ACPI 2.0 interface
• LPC bus interface to support BMC
26
Chapter 1