Accessing Internal Components For A Pedestal-Mounted Server; Pedestal Mounted Server Ready For Servicing - HP Integrity rx2660 Installation Manual

3 Accessing Internal Components for a Pedestal–Mounted
Server
Follow this procedure to access internal components for a pedestal-mounted server.
1. Power down the server and remove all cables.
2. Remove the pedestal kit feet.
3. Lay the server on the right side (facing the front of the server). The left side of the pedestal
kit (with the ventilation holes) should be facing up.
4. Unscrew the captive thumbscrews on the rear of the pedestal kit for the left side pedestal
kit piece.
5. Slide the left side pedestal kit piece toward the back of the server, and lift up on the piece
to remove it from the pedestal.
6. Remove the top cover of the server by lifting up on the cover release lever, and sliding the
top cover toward the rear of the server. See
Figure 3-1 Pedestal Mounted Server Ready for Servicing
The server is ready for servicing.
Once servicing is complete, do the following to put the pedestal kit back on the server.
1. Install the left side pedestal piece.
2. Tighten the thumbscrews on the rear of the server.
3. Stand the server up onto the bottom piece of the pedestal kit.
4. Install the pedestal kit feet into the slots on the bottom piece of the pedestal kit.
5. Connect the cables and restart the server.
Figure 3-1 (page 15).
15