SATO CL408 Programming Reference Manual page 56

JOB ID, STORE
FUNCTION
To add an identification number to a job. The status of the job can then be determined using
the ENQ command in the Bi-Com status mode.
FORMAT
<ESC>IDaa
Place immediately following the <ESC>A in the job data stream.
EXAMPLE <ESC>A
<ESC>ID01
<ESC>V200<ESC>H100<ESC>P0<ESC>$B,100,100,6
<ESC>$=SATOPRINTER
<ESC>Q2
<ESC>Z
OUTPUT This command does not result in printer output.
NOTES
When status return is used on interface protocol, the specified Job ID Number can be set at the
telegraphic status. The status can confirmed by sending status request (ENQ).
Status return interface protocol is valid when status request (ENQ) is received during printing. At the
status return interface protocol,
E/Pro Programming Reference
Unit 4: Standard Command Codes
aa = Job ID assigned (00 to 99)
4-4
PN: 9001096E