Cloning; Cloning Operation - Icom IC-V80 Instruction Manual

Previous view
11

CLONING

■ Cloning operation

Cloning allows you to quickly and easily transfer the
programmed contents from one transceiver to another,
or data between a personal computer and a transceiv-
er, using the optional CS-V80 or CS-U80 cloning soft-
ware.
D Cloning between two transceivers
q Turn OFF the power, and then connect the master
and sub-transceivers using the OPC-474 cloning
cable through their speaker jacks.
• The master transceiver is used to send data to the sub-
transceiver.
w While holding down [FUNC](M) and [Y], turn ON the
master transceiver to enter the cloning mode.
• "CLOnE" appears
e Turn ON the sub-transceiver.
r Push [PTT] on the master transceiver.
• "CL Out" appears on the master transceiver's display, and
the signal icon shows that data is being transferred to the
sub-transceiver.
• "CL In" appears on the sub-transceiver's display, and the
signal icon shows that data is being received from the
master transceiver.
t When the cloning is fi nished, turn OFF both trans-
ceiver's power, and then turn ON the power again to
exit the cloning mode.
NOTE:
• DO NOT push [PTT] on the sub-transceiver during
cloning. This will cause an error.
• DO NOT disconnect the cloning cable or turn OFF
the power during cloning. This will cause an error.
D Cloning using a PC
Data can be transferred to and from a PC, using the
optional CS-V80 or CS-U80 cloning software and an
OPC-478 (RS-232C type) or OPC-478UC (USB type)
.
CLONING CABLE
Consult the INSTRUCTIONS and the Help fi le that
come with the cloning software, for details.
Master transceiver
During cloning mode
OPC-478UC
(USB type)
OPC-478
(RS-232C type)
Transceiver
45
Sub transceiver
to USB port
to RS-232C
port
PC