Dtmf Memory; Programming A Dtmf Code Sequence - Icom IC-V80 Instruction Manual

Previous view
9

DTMF MEMORY

■ Programming a DTMF code sequence

DTMF codes are used for autopatching, controlling
other equipment, and so on. The transceiver has up to
16 DTMF memory channels (d0–dF) for up to 24 digits
often-used DTMF codes.
q Push [FUNC](M), and then push [DTMF-M](0) to en-
ter the DTMF memory mode.
w Push [Y] or [Z] to select the desired blank DTMF
memory channel.
• The selected DTMF memory channel blinks.
• If programmed, the previously programmed DTMF code
is displayed.
e NOTE: Previously programmed code sequence in
the selected DTMF memory channel will be
cleared by following operation.
Push [FUNC](M), and then hold down [DTMF-M](0) for 1
second to enter the DTMF memory programming mode.
• "_ _ _ _ _" appears.
r Push a key to input the desired DTMF code.
• Refer to the illustration below for the DTMF code assignment.
• If a digit is mistakenly input, push [PTT] momentarily, and
then repeat from step e.
t Repeat step r, until the desired DTMF code se-
quence (up to 24 digits) is complete.
• When the 6th character is set, the icon displays the next
blank digit group.
y Push [PTT] to save the channel and exit the DTMF
memory programming mode.
• After the 24th digit is input, the transceiver automatically
saves the code sequence and returns to the DTMF mem-
ory mode (step w).
u Push [VFO/MR/CALL] to exit the DTMF memory
mode.
• DTMF code assignment
Numeric input
" (E)"
• Programming mode indication
The programming mode consists of 5 groups.
Group Digits
1st 1st to 5th
2nd 6th to 10th
3rd 11th to 15th
4th 16th to 20th
5th 21st to 24th
"A"
"B"
"C"
"D"
"# (F)"
Icon
No icon.
" " appears.
" " appears.
" " appears.
" " blinks.
[i.e.]: Programming "123456" into
the DTMF memory channel "d3."
Push , and then push
Push or to select DTMF memory channel "d3."
Push , and then hold down
Push keys, until the desired DTMF code is complete.
Push [PTT].
Push to exit the DTMF memory mode.
33
.
(DTMF memory mode)
for 1 second.
(DTMF memory programming mode)
The next page appears when
the 6th digit has been input.