Programming A Channel Name; Memory/Call Operation - Icom IC-V80 Instruction Manual

Previous view
6

MEMORY/CALL OPERATION

■ Programming channel names
Each memory channel and the Call channel can be pro-
grammed with an alphanumeric channel name, for easy
recognition. Names can be a maximum of 5 characters.
D Setting the display type
q Hold down [ ] for 1 second to turn OFF the power.
w While holding down [Y] and [Z], turn ON the power
to enter the Initial Set mode.
e Push [Y]/[Z] to select the display type item. (dSP)
r Rotate [VOL] to select "dSP.nm."
t Push [# ENT] to exit the Initial Set mode.
D Programming a channel name
q Select the channel name display in the Initial Set mode.
(See the above topic.)
w Push [VFO/MR/CALL] several times to select the memory
mode or Call channel mode.
• For memory channel:
Push [Y] or [Z] to select the desired memory channel.
e Push [FUNC](M), and then push [SET](8) to enter
the channel name programming mode.
• A cursor blinks for the fi rst character.
r Rotate [VOL] to select a character.
• The selected character blinks.
t Push [Y] to move the cursor right, push [Z] to move
the cursor left.
y Repeat steps r and t, until the desired channel
name is completed.
u Push [# ENT] to exit the programming mode.
D Selectable characters
(A) (b) (C) (d) (E) (F) (G)
(n) (O) (P) (q) (R) (S) (t)
(1) (2) (3) (4) (5) (6) (7)
∗
( + ) ( - ) ( = ) / ( ( ) ( ) )
( ) ( )
(H) ( I ) (J) (k) (L) (m)
(U) (V) (W) (X) (y) (Z)
(8) (9) (0)
: (Space)
( )
• The "Display type" item in the Initial Set mode
("Name" is selected)
[i.e.]: Programming "CALL" into memory channel 12.
Push or to select channel 12.
Push , and then push
Rotate [VOL] to select the character,
and then push or
Repeat until the name is complete.
Push to exit the programming mode.
25
(Memory mode)
.
to move the cursor.