Key Lock Function; [Vol] Function Assignment; Selecting Output Power - Icom IC-V80 Instruction Manual

Previous view
4
BASIC OPERATION

■ Key Lock function

Use the Key Lock function to prevent accidental frequency
or channel change or unnecessary function access.
➥ Push [FUNC](M), and then hold down [
1 second to turn the Key Lock function ON or OFF.
• " " appears while the Key Lock function is ON.
• [ ], [VOL], [MONI], [PTT] and [FUNC](M) + [
are still operable while the Key Lock function is ON.

■ [VOL] function assignment

[VOL] can be used as a tuning control instead of [Y]
and [Z], to suit your preference. However, when [VOL]
functions as a tuning control, [Y] and [Z] function as
volume controls.
q While holding down [Y] and [Z], turn ON the power
to enter the Initial Set mode.
w Push [Y] or [Z] to select the dial assignment item
(tOP).
e Rotate [VOL] to select an option.
r Push [# ENT] to exit the Initial Set mode.
[VOL] and [Y]/[Z] function as described below, de-
pending on the option.
Option [VOL]
tOP.VO Volume control
tOP.di Tuning control

■ Selecting output power

The transceiver has 3 output power levels to suit your
operating requirements. Lower output powers during
short-distance communications may reduce the pos-
sibility of interference to other stations and will reduce
current consumption.
➥ Push [FUNC](M), and then push [H/M/L](9) several
times to select the desired output power.
• OUTPUT POWER (approximately)
Output power
Level
IC-V80/V80E
Low 0.5 W
Mid 2.5 W
High 5.5 W
](# ENT) for
](# ENT)
[Y]/[Z]
Tuning controls
Volume controls
IC-U80/U80E
0.5 W
2.0 W
4.0 W
Push , and then hold down
Appears
• The "Dial assignment" item in the Set mode
[VOL] functions as the volume control.
[VOL] functions as the tuning control.
Push , and then push
to select the desired output power.
Low power
Appears
Mid power
Appears
15
for 1 second.
several times
High power
Appears