Lockout Function; Auto Repeater Function (Only Usa Version Of Ic-V80); Repeater And Duplex Operations - Icom IC-V80 Instruction Manual

Previous view
5

REPEATER AND DUPLEX OPERATIONS

■ Lockout function

This function helps prevent interference to other stations
by inhibiting transmitting when a signal is received. The
transceiver has two inhibiting conditions; repeater and
busy.
q Hold down [ ] for 1 second to turn OFF the power.
w While holding down [Y] and [Z], turn ON the power
to enter the Initial Set mode.
e Push [Y] or [Z] to select the lockout item (RLO).
r Rotate [VOL] to select the Lockout function option of
.
"RP," "bU" or "OF "
• "RLO.OF" : The Lockout function is OFF.
• "RLO.RP" : The transmit is inhibited when a signal
with an un-matched subaudible tone is re-
ceived.
• "RLO.bU" : Transmit is inhibited when a signal is re-
ceived.
r Push [# ENT] to exit the Initial Set mode.
■ Auto Repeater function
The USA version automatically activates the repeater
settings (DUP– or DUP+ and tone encoder ON/OFF),
when the operating frequency falls within the general
repeater output frequency range. It deactivates them
when outside of the range.
q Hold down [ ] for 1 second to turn OFF the power.
w While holding down [Y] and [Z], turn ON the power
to enter the Initial Set mode.
e Push [Y] or [Z] to select the Auto Repeater item (RPt).
r Rotate [VOL] to set the Auto Repeater function to
"R1," "R2" or "OF."
• "RPt.OF" : The Auto Repeater function is OFF.
• "RPt.R1" : The Auto Repeater function is ON (For only
duplex).
• "RPt.R2" : The Auto Repeater function is ON (For du-
plex and tone encoder).
t Push [# ENT] to exit the Initial Set mode.
• Frequency range and offset direction
Frequency range
145.200–145.495 MHz
146.610–146.995 MHz
147.000–147.395 MHz
• The "Lockout" item in the Initial Set mode
Only USA version of IC-V80
Duplex direction
"–" appears.
"+" appears.
20
(The Repeater Lockout function is OFF. )
(The Repeater Lockout function is ON. )
(The Busy Lockout function is OFF. )
• The "Auto repeater" item in the Initial Set mode
Auto Repeater function is OFF.
Auto Repeater function is ON
(For only duplex).
Auto Repeater function is ON
(For duplex and tone encoder).