Accessories; Antenna; Belt Clip; Battery Pack Or Case - Icom IC-V80 Instruction Manual

Previous view
1

ACCESSORIES

■ Antenna

Insert the antenna into the antenna connector and twist
the antenna base to lock it in place.
CAUTION:
• NEVER HOLD just the antenna when carrying the
transceiver.
• Transmitting without an antenna will damage the
transceiver.

■ Belt clip

To attach the belt clip:
➥ Slide the belt clip in the direction of the arrow until the
belt clip locks in place, and makes a 'click' sound.
Belt clip
Battery pack/case
To detach the belt clip:
q Remove the battery pack or case from the transceiv-
er, if it is attached.
w Lift the tab up (q), and slide the belt clip in the direc-
tion of the arrow (w).
q
w

■ Battery pack or case

To attach the battery pack or case:
q Fit the battery pack or case in the direction of the ar-
row (q), then close.
w Hook the latch until it makes a 'click' sound (w).
To remove the battery pack or case:
R WARNING! The latch is tightly locked, so use caution
when releasing it. DO NOT use your fi ngernail. Use the
edge of a coin or screwdriver tip to carefully release it.
➥ Unhook the latch (z), and then lift up the battery
pack or case in the direction of the arrow (x).
CAUTION: NEVER remove or attach the battery
pack or case when the transceiver is wet or soiled.
This may result in water or dust getting into the trans-
ceiver or the battery pack or case, and may result in
them being damaged.
NOTE: Keep battery terminals clean. It's a good idea
to occasionally clean them.

■ Jack cover

Attach the jack cover when optional equipment is not
used.
To attach the jack cover
q Attach the jack cover to
the [SP MIC] jack.
w Insert and tighten the
screws.
q
1
q
Battery pack/case
w
Latch
x
z
To detach the jack cover
z Remove
the
with a phillips screw-
driver.
x Detach the jack cover to
connect optional equip-
ment.
z
w
z
w
screws
x