6
OTHER FUNCTIONS
Cloning
The transceiver has a data copying capability. This function is useful for copying all of the settings and entered
contents from one transceiver to another.
D Cloning between two transceivers
An optional OPC-474 programming cable or 3.5 mm
(1/8 inch) stereo jack cable (user supplied) is required.
1. Turn OFF the transceivers, and connect the
master and sub-transceivers using the OPC-474
or stereo jack cable through their [SP] jacks.
2. Turn ON the sub-transceiver.
3. While holding down [V/M/C], turn ON the master
transceiver to enter the Cloning mode.
• "CLOnE m" is displayed.
4. Push [PTT] on the master transceiver to start
cloning.
• While cloning, "CL Out" is displayed on the master
transceiver's function display.
• While cloning, "CL In" is displayed on the sub-
transceiver's function display.
• When the cloning is finished, "CL End" is displayed on
the sub-transceiver's function display.
OPC-474
or
3.5 mm (1/8 inch)
stereo jack cable
(User supplied)
D Cloning using a PC
Copy the data using the optional CS-T10
programming software and an OPC-478UC/OPC-
478UC-1 programming cable.
Refer to the INSTRUCTIONS and the Help file that
come with the programming software, for details.
CAUTION: BE SURE to turn OFF the transceiver,
before connecting or disconnecting an optional
equipment to or from the [MIC/SP] jack.
OPC-478UC/OPC-478UC-1
6-11