Icom IC-V80 Step-By-Step Programming Manual

Icom IC-V85 Step-by-Step Programming Guide
Also applies to IC-V80

Set the radio to communicate with a repeater at 146.780- MHz, 100.0 Hz

0. Turn on the radio and make sure it's unlocked
1. CLR (VFO mode)
2. Set the frequency
1 - 4 - 6 - 7 - 8 - 0
3. If the – sign appears at the top, skip to step 6
4. Set the repeater offset
FUNC - 8 - (± 0.60) - CLR
5. Set the repeater shift direction
FUNC - 4 (–)

Store and name the current repeater and tone settings in a memory channel

0. Follow the procedure above to set your radio
for the frequency of your choice
1. Store the frequency in channel 37
FUNC - M R - (37) - FUNC - M R (hold)
The frequency is now stored in radio memory

Recall a stored memory setting

0. Turn on the radio and make sure it's unlocked
1. M R (channel mode)
2. Select the tw o-digit channel number
3 - 7
The stored channel is now ready for use
6. Set the transm it tone frequency
FUNC - 8 (rt) - rotate volume (100.0) - CLR
FUNC - 1 ( )
7. Set the transm it pow er level
FUNC - 9 (H) - CLR
Your radio is now set to transm it as specified
2. M R (channel mode)
3. Set NAM E mode
FUNC - 8
(If this doesn't put you in name edit mode,
turn off the radio, then
sim ultaneously, then select dSP.Nm)
4. Rotate the knob and then
then CLR
The stored m em ory channel now has a name
Noji Ratzlaff
and PW R
and
to edit the nam e,