Memory/Call Operation; General Description; Programming Memory/Call Channel - Icom IC-V80 Instruction Manual

Previous view
6

MEMORY/CALL OPERATION

■ General description

The transceiver has 207 memory channels, including
6 scan edge memory channels (3 pairs), and 1 Call
channel. These channels can be individually pro-
grammed with:
• Operating frequency (p. 13)
• Passband width (p. 13)
• Duplex direction (+ or –) with frequency offset (p. 18)
• Reversed Duplex function ON/OFF (p. 18)
• Subaudible tone encoder (p. 19), tone squelch or DTCS
squelch ON/OFF (p. 31)
• Subaudible tone frequency (p. 19), CTCSS tone frequen-
cy or DTCS code with polarity (p. 30)
• Skip setting (p. 28)
• Tuning step (p. 13)
• Output power (p. 15)
• TX permission (p. 39)

■ Programming memory/Call channel

q Push [VFO/MR/CALL] several times to select the VFO
mode.
w Set the desired frequency.
➥ If desired, set other data (e.g. frequency offset,
duplex direction, tone squelch, and so on.).
e Push [FUNC](M), and then push [VFO/MR/CALL].
• "X" and the memory channel number blink.
r Push [Y] or [Z] to select the memory channel to be
programmed.
• Select 1A/b, 2A,b or 3A/b to program a scan edge chan-
nel. (p. 27)
• Select the Call channel ("C") to program the Call chan-
nel.
t Push [FUNC](M), and then hold down [VFO/MR/CALL]
for 1 second to program.
• 3 beeps sound.
• The memory channel number automatically increases,
when continuing to hold down [VFO/MR/CALL] after pro-
gramming.
NOTE: To cancel programming, push [VFO/MR/CALL]
before doing step t.
[i.e.]: programming 145.440 MHz into memory channel 11.
Set the frequency.
Push , and then push
Push or to select channel 11.
Push , and then hold down
Automatically returns to the VFO mode.
21
(VFO mode)
.
for 1 second.