D Setting Output Power; D Setting Microphone Gain - Icom IC-7000 Instruction Manual

D Setting output power

q Push [AF(
)] momentarily to enter the set mode
SET
menu.
w Push [F-1 Q Q S S ] to enter the quick set mode.
e Push [F-1 Y] or [F-2 Z] to select "R R F F P P o o w w e e r r ."
r Rotate [DIAL] to set the desired output setting.
• Output power is displayed in 1% steps (0% to 100%).
t Push [Z Z (
)] to exit quick set mode.
/
MENU GRP
• Available power
SSB/CW
BAND
RTTY/FM
HF 2–100 W
50 MHz 2-100 W
144 MHz 2–50 W
430 MHz 2–35 W
*Carrier power
If a linear amplifier is connected such as the IC-PW1/EURO,
set the output power using the ALC meter (see below) to
ALC zone (ALC meter reading should be within this zone),
otherwise the linear amplifier will not work properly.

D Setting microphone gain

Microphone gain must be adjusted properly so that
your signal is not distorted when transmitted.
q Select SSB or another phone mode (AM or FM
mode).
w Select S S - - 1 1 .
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group S S .
• Push [MENU/GRP] momentarily one or more times to
select the menu S S - - 1 1 .
e Push [F-3 M M E E T T ] one or more times to select the
ALC meter.
• "ALC" appears.
r Push [AF(
)] momentarily to enter the set mode
SET
menu.
t Push [F-1 Q Q S S ] to enter the quick set mode.
y Push [F-1 Y] or [F-2 Z] to select "M M I I C C G G a a i i n n ."
u Push [PTT] (microphone) to transmit.
• Speak into the microphone at your normal voice level.
i While speaking into the microphone, rotate [DIAL]
so that the ALC meter reading does not go outside
the ALC zone.
• Microphone gain is adjusted in 1% steps (0% to 100%).
o Release [PTT] (microphone) to return to receive.
!0 Push [Z(
)] to exit the quick set mode.
/
MENU GRP
• Push [Z Z (
)] again to return the normal oper-
/
MENU GRP
ating mode.
AM*
1–40 W
1–40 W
2–20 W
2–14 W
the
ALC
BASIC OPERATION
[AF]
[MENU/GRP] [F-1] [F-2]
[AF]
[MENU/GRP] [F-1] [F-2] [F-3]
ALC zone
3
[DIAL]
3
[DIAL]
38