Blade Configuration Parameters - Qlogic SANbox 9000 Series Interface Manual

A
Set Config Blade
Initiates an edit session in which to change an I/O blade configuration. The
changes you make with this command are not retained when you reset or power
cycle the switch unless you save them using the Config Save command.
Authority
Admin session and a Config Edit session
Syntax
set config blade [blade_ID]
Keywords
[blade_ID]
The I/O blade given by [blade_ID] for which to change the configuration.
[blade_ID] can be IO0–IO7. If you omit [blade_ID], the system prompts you
sequentially to modify all I/O blades. Enter a new value or press the Enter key to
accept the current value shown in brackets. Enter "q" to end the configuration for
one blade, or "qq" to end the configuration for all blades.
the I/O blade configuration parameters.
BladeType
AdminState
59231-03 A
Table 15-17. Blade Configuration Parameters
Parameter
Blade type:
I/O blade administrative state:
Description
Auto – Automatically configures the blade type to match
that of the installed I/O blade. This is the default.
FC4G16 – Fibre Channel 1/2/4-Gbps 16-port
FC10G4 – Fibre Channel 10-Gbps 4-port
Online – Activates and prepares the I/O blade to send
data. This is the default.
Offline – Prevents the I/O blade from receiving signals
and accepting a device logins.
Diag – Prepares the I/O blade for testing and prevents
the port from accepting a device login.
Down – Disables the I/O blade by removing power from
the port lasers.
PwrdOff – Removes power for the I/O blade.
15 – Command Reference
Set Config Blade
Table 15-17 describes
15-73