Modifying The Security Database; Resetting The Security Database - Qlogic SANbox 9000 Series Interface Manual

10 – Device Security Configuration

Modifying the Security Database

10.3
Modifying the Security Database
To modify the security database, you must open an Admin session with the
Start command. An Admin session prevents other accounts from making changes
at the same time either through Telnet or Enterprise Fabric Suite 2007. You must
also open a Security Edit session with the Security Edit command. The
Security Edit session provides access to the Securityset, Group, and
commands with which you make modifications to the security database.
SANbox #> admin start
SANbox (admin) #> security edit
SANbox (admin-security)#> securityset . . .
SANbox (admin-security)#> group . . .
SANbox (admin-security)#> security . . .
When you are finished making changes, enter the Security Save command to
save the changes and close the Security Edit session.
SANbox (admin-security)#> security save
To close the session without saving changes, enter the Security Cancel
command.
SANbox (admin-security)#> security cancel
Changes to the active security set do not take effect until you activate it with the
Security Activate command. The Admin End command releases the Admin
session for other administrators when you are done making changes to the
switch.
SANbox (admin)#> security activate
SANbox (admin)#> admin end
10.4

Resetting the Security Database

There are two ways to remove all groups and security sets from the security
database:
Enter the
SANbox (admin-security) #> security clear
All security information will be cleared.
SANbox (admin-security) #> security save
Enter the
security configuration values, autosave and fabric binding remain
unchanged.
SANbox (admin) #> reset security
10-8
Security Clear command as shown in the following example:
Reset Security command as shown in the following example. The
Please confirm (y/n): [n] y
S
Admin
Security
59231-03 A