Qlogic SANbox 9000 Series Interface Manual page 201

A
Hardreset
Resets the switch or the specified blade and performs a power-on self test. This
reset disrupts I/O traffic activates pending firmware, and clears the alarm log. To
save the alarm log before resetting, refer to the
page 15-87.
Authority
Admin session
Syntax
hardreset
blade [blade_ID]
switch
Keywords
blade [blade_ID]
Reset set the I/O blade or secondary CPU blade given by [blade_ID]. [blade_ID]
can be IO0–IO7, or CPU1. This command will not reset the primary CPU; use the
Hardreset Switch command instead.
switch
Reset the switch with a Power-on self test.
Notes
To reset the switch without a power-on self test, refer to the
page 15-51.
To reset the switch without disrupting traffic, refer to the
page 15-38.
59231-03 A
15 – Command Reference
"Set Log" command on
"Reset" command on
"Hotreset" command on
Hardreset
15-35