Qlogic SANbox 9000 Series Interface Manual page 367

A
create [zone_set]
Creates the zone set with the name given by [zone_set]. A zone set name must
begin with a letter and be no longer than 64 characters. Valid characters are 0-9,
A-Z, a-z, _, $, ^, and -. The zoning database supports a maximum of 256 zone
sets. You must enter the
deactivate
Deactivates the active zone set. Close the Zoning Edit session before using this
keyword.
delete [zone_set]
Deletes the zone set given by [zone_set]. If the specified zone set is active, the
command is suspended until the zone set is deactivated. You must enter the
Zoning Save
list
Displays a list of all zone sets. This keyword does not require an Admin session.
remove [zone_set] [zone_list]
Removes a list of zones given by [zone_list] from the zone set given by
[zone_set]. Use a <space> to delimit zone names in [zone_list]. If [zone_set] is the
active zone set, the zone will not be removed until the zone set has been
deactivated. You must enter the
changes.
rename [zone_set_old] [zone_set_new]
Renames the zone set given by [zone_set_old] to the name given by
[zone_set_new]. You can rename the active zone set. You must enter the
Zoning Save
zones [zone_set]
Displays all zones that are components of the zone set given by [zone_set]. This
keyword does not require an Admin session.
Notes
A zone set must be active for its definitions to be applied to the fabric.
Only one zone set can be active at one time.
A zone can be a component of more than one zone set.
59231-03 A
Zoning Save
command afterwards to save your changes.
Zoning Save
command afterwards to save your changes.
15 – Command Reference
command afterwards to save your changes.
command afterwards to save your
Zoneset
15-201