Qlogic SANbox 9000 Series Interface Manual page 88

7 – Port Configuration
Configuring Port Threshold Alarms
Enter the
monitoring on the switch:
SANbox #> admin start
SANbox
SANbox (admin-config) #> set config threshold
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
ThresholdMonitoringEnabled
CRCErrorsMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
DecodeErrorsMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
ISLMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LoginMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LogoutMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
LOSMonitoringEnabled
RisingTrigger
FallingTrigger
SampleWindow
Finished configuring attributes.
This configuration must be saved (see config save command) and activated (see
config activate command) before it can take effect.
To discard this configuration use the config cancel command.
SANbox (admin-config) #> config save
SANbox (admin-config) #> config activate
7-12
Set Config Threshold
(admin) #> config edit
command to enable and configure port threshold
(True / False)
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
(True / False)
(decimal value, 1-1000)
(decimal value, 0-1000)
(decimal value, 1-1000 sec) [10
S
[False ]
[True ]
[25 ]
[1 ]
]
[True ]
[25 ]
[0 ]
]
[True ]
[2 ]
[0 ]
]
[True ]
[5 ]
[1 ]
]
[True ]
[5 ]
[1 ]
]
[True ]
[100 ]
[5 ]
]
59231-03 A