Qlogic SANbox 9000 Series Interface Manual page 240

15 – Command Reference
Set Config Blade
Examples
The following is an example of the Set Config Blade command:
SANbox #> admin start
SANbox (admin) #> config edit
SANbox (admin-config) #> set config blade io2
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Blade: IO2 (Current Blade Type=FC4G16)
------------------
BladeType
AdminState (1=Online, 2=Offline, 3=Diag, 4=Down, 5=PwrdOff) [Online]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
15-74
(1=FC4G16 16 4G FC ports
2=FC10G4 4 10G FC ports
3=Auto)
S
[Auto ]
59231-03 A