Changing Air Direction; Air Conditioner Care; Cleaning The Air Filter - Whirlpool W7WCC085XB0 Use & Care Manual

NOTES:
• When 6thSense
TM
System Control is selected, the unit will
measure the current room temperature sent by the remote
control. If the unit does not receive a signal from the remote
control, the current room temperature will be measured by
the unit.
• Signals between the unit and the remote control can be
checked by raising and lowering the thermostat temperature.
• To turn off 6thSense
TM
System Control, press 6thSense on the
remote control. The 6thSense icon on the air conditioner
control panel will turn off. The unit will return to the previous
settings for cool, fan speed and temperature.
Fan Speed
1. Press FAN SPEED until you see the Bar LED on the air
conditioner control panel display for the desired setting.
2. Choose Low, Medium, High or Auto.
NOTES:
• Auto fan speed and Temperature cannot be selected
in Fan Only mode.
• In Eco and Cool modes, Auto fan speed is selected
automatically.
Fan Speed
NOTE: After 5 seconds, the display on the air conditioner control
panel will show the current room temperature.
Temperature
• Press the up arrow button to raise the temperature. Each time
you press or hold the up arrow button, the temperature will go
up I°F (1°C) until it reaches 86°F (30°C). The up LED on the
air conditioner control panel will light
Press the down arrow button to lower the temperature. Each
time you press or hold the down arrow button, the
temperature will go down I°F (1°C) until it reaches 61°F
(16°C). The down LED on the air conditioner control panel will
light.
Use tab to direct the air right or left.
A. Tab
AIRCONDITIONER C ARE
Your new air conditioner is designed to give you many years of dependable service. This section tells you how to clean and care for your
air conditioner properly. Call your local authorized dealer for an annual checkup. Remember ... the cost of this service call is your
responsibility.
The air filter is removable for easy cleaning. A clean filter helps
remove dust, lint, and other particles from the air and is important
for best cooling and operating efficiency. Check the filter every
2 weeks to see whether it needs cleaning.
NOTE: Do not operate the air conditioner without the filter in
place.
1. Turn off the air conditioner.
2. Remove the air filter by pressing down on the tabs on the air
intake grille and pulling the grille away from the air
conditioner.
17