Download Print this page

Changing Air Direction; Exhaust Air Vent; Normal Sounds - Whirlpool ROOM AIR CONDITIONER Use & Care Manual

Room air conditioner
Hide thumbs

Advertisement

Table of Contents
4. For Fan mode, adjust fan speed to High, Med or Low.
NOTE: In Fan mode, temperature cannot be set.
5. For 6
th
Sense
System control, adjust fan speed to High,
Med, Low or Auto.
6. For Dry mode and 6
th
Sense
temperature up or down by 4ºF (2ºC).
7. Turn off air conditioner.
8. Press TIMER. Timer indicator light on the air conditioner
control panel will flash.
9. Press up or down arrow button to change the delay time from
30 minutes to 24 hours.
10. After 5 seconds, Timer indicator light on the air conditioner
control panel will remain on.
Use wheel to direct the air right or left. Use the whole cartridge to direct air up, down or straight ahead.
A. Wheel
Pull out the exhaust air vent control to Open the exhaust air
vent and draw stale or smoky air from the room.
Push in the exhaust air vent control to close the exhaust air
vent for maximum continuous cooling.
When your air conditioner is operating normally, you may hear
sounds such as:
Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.
Air movement from the fan.
System control, adjust

Changing Air Direction

A

Exhaust Air Vent

Normal Sounds

To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press TIMER
again. Timer indicator light will turn off.
To see or change the remaining time (in hours):
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press the up
or down arrow button to increase or decrease the time.
3. After 5 seconds, the display will show the current room
temperature.
A
A. Cartridge
A. Exhaust air vent control
NOTE: The exhaust air vent control will function only when the
Fan Speed control is operating.
Clicks from the thermostat cycle.
Vibrations or noise due to poor wall or window construction.
A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.
A
17

Advertisement

Table of Contents
loading

  Related Manuals for Whirlpool ROOM AIR CONDITIONER