INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Phillips screwdriver
•
Tape measure
•
Scissors
•
Cordless drill and 1/8"bit
•
Level
•
Pencil
NOTE: Cabinet louvers must not be obstructed.
Air must be able
to pass freely through the cabinet louvers.
Parts supplied
Check that all parts are included in parts package.
B
A
A. Cabinet louvers
A. Foam seal with adhesive
strip
B. Foam seal without
adhesive
strip
C. Window lock bracket
D. Side bracket (on some
models)
E. %" screws (4) (6300 and 8k models only)
F _" screws (5) (6 providedon
lOkand
12k
models)
G. Side curtains (2)
H. Top channel seal (on some models)
I. Top channel (on some models)
Window installation
Window Opening
Measurements--Small
Chassis:
6300 Btu and 8000 Btu:
•
21" (53.3 cm) minimum to 331/2" (85 cm) maximum opening
width.
•
131/2" (34.3 cm) minimum opening height
Window
Opening
Measurements--
Large Chassis"
1Ok and
12k Btu
•
24" (61 cm) minimum to 36" (91.4 cm) maximum opening
width.
•
15" (38.1 cm) minimum opening height.
:_,IR()II{
II
IMPORTANT:
Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed.
Make sure you have everything necessary for correct installation.
The location should provide:
•
Grounded electrical outlet within 6 ft (183 cm) of where the
power cord exits the air conditioner.
NOTE: Do not use an extension cord.
•
Free movement of air in room to be cooled.
•
A large enough opening for the air conditioner. Installation
parts are supplied for double-hung
windows.
•
Adequate wall support for weight of air conditioner. Air
conditioner
weighs 50 Ibs to 75 Ibs (22.7 kg to 34 kg).
B
)
I
'v
L
l
I
A. Small chassis: 21" (53.3 cm) minimum;
Large chassis: 24" (61 cm) minimum
B. Small chassis: 13½" (34.3 cm) minimum;
Large chassis: 15" (38.1 cm)minimum