Whirlpool W7WCC085XB0 Use & Care Manual page 14

FanSpeed
1. NOTES:
• Auto fan speed and Temperature cannot be selected
2. in Fan Only mode.
• In Eco and Cool modes, Auto fan speed is selected
automatically.
Press FAN SPEED until you see the Bar LED display for the
desired setting.
Choose High, Med, Low or Auto.
• Low--Low cooling--1 bar and "1" shows in the
temperature display
• Med--Normal cooling--2 bars and "2" shows in the
temperature display
• High--Maximum cooling--3 bars and "3" shows in the
temperature display
• Auto--Automatically controls the fan speed depending on
the current room temperature and temperature control
setting. "A" shows in the temperature display and 1,2 or
3 bars display the current fan speed.
Fan Speed
NOTE: After 5 seconds, the display will show the current room
temperature.
Temperature
Press the up arrow button to raise the temperature. Each time
you press or hold the up arrow button, the temperature will go
up I°F (1°C) until it reaches 86°F (30°C).
NOTE: After 5 seconds, the display will show the current
room temperature.
Press the down arrow button to lower the temperature. Each
time you press or hold the down arrow button, the
temperature will go down I°F (1°C) until it reaches 61 °F
(16°C).
NOTE: After 5 seconds, the display will show the current
room temperature.
To change from Fahrenheit to Celsius
Press and hold the up and down arrow buttons to change from F°
to C ° . Release the buttons after C° turns on.
Set Clock
NOTES:
• The Clock must be set to the correct time for the Timed
Function to operate properly.
The first time the air conditioner is plugged in, the Set Clock
button LED will flash for 30 seconds or until the clock is
programmed.
To reset the clock, the air conditioner can be in Standby
mode, with the red LED glowing, or running, with the blue
LED glowing.
1. Press SET CLOCK.
2. Press the up or down arrow button to set AM or PM and the
current hour.
3. Press SET CLOCK.
4. Press the up or down arrow button to set the current minutes.
5. Press SET CLOCK again to save settings.
Set Cmock
14