For Heating Using the Exhaust Vent Control 01988 Whirlpool Corporation Thank you for buying a Whirlpool product. Please complete and mail the Owner Registration Complete the form below. Have this information ready when you need service or call with a question.
To remove the Consumer Buy Guide label and energy rating label lift one edge and pull straight off. To remove any remaining glue: Rub briskly with thumb to make a ball, then remove. -or- 2. Soak area with a liquid hand dishwashing detergent before removing glue as described in step 1.
For Heating NOTE: This product Is not deolgned to be used as a primary heat source. It Is intended supplemental heating only. LO HEAT for reduced air movement with heat. HI HEAT for maximum air movement with heat. Model ACH082 ONLY Use of the heat settings on this model activates a reverse cycle operation that works as a heat pump.
Changing Air Direction The louvers in the grille area at the top of the air conditioner control the direction of the conditioned air. The tabs at the bottom of the grille can be moved to the right, left or straight ahead. Move the tabs in the direction in which you want the air to flow.
An easy to use capsule of especially recommended oil (Part Number 10943) is available through your nearest Whirlpool Factory Service Center, or use SAE #20 non-detergent oil. 3. Replace the plugs to keep dirt from motor yourself.
Whirlpool appliance. To locate FSP replacement Step 3 above or call the Whirlpool COOL-LINE service assistance number in Step 2. *If You must call or write, please number, serial number, date of purchase, and a com- tele- plete description of the problem.
Service under the full warranties must be provided by a franchised TECH-CARE@ service company. WHIRLPOOL CORPORATION SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion or limitation of incidental or consequential damages so this limitation or exclusion may not apply to you.