Cleaning The Front Panel; Repairing Paint Damage; Annual Maintenance; Troubleshooting - Whirlpool W7WCC085XB0 Use & Care Manual

Window type
Table of Contents

Advertisement

Available languages

Available languages

3.
Remove the filter from the grille by lifting to release the
slotted tabs on the top and bottom of the grille.
A
B
C
A. Slotted tab
C. Air intake grille
B. Lift slotted tab to remove.
D. Air filter
D
4. Use a vacuum cleaner to clean air filter. If the air filter is very
dirty, wash it in warm water with a mild detergent.
NOTE: Do not wash the air filter in the dishwasher or use any
chemical cleaners. Air dry the air filter completely
before
replacing to ensure maximum efficiency.
5. Reattach the air filter to the air intake grille.
6. Insert the air intake grille into the slots on the air conditioner
and snap into place.
1. Turn off the air conditioner.
2. Clean the front panel with a soft, damp cloth.
3. Air dry the front panel completely.
Check once or twice a year for paint damage. This is very
important,
especially in areas near oceans or where rust is a
problem. If needed, touch up with a good grade enamel paint.
Your air conditioner
needs annual maintenance to help ensure
steady, top performance throughout
the year. Call your local
authorized dealer to schedule an annual checkup. The expense
of an annual inspection is your responsibility.
TROUBLESHOOTING
Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.
Air conditioner will not operate
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
The power supply cord is unplugged. Plug into a grounded
3 prong outlet. See "Electrical Requirements."
The power supply cord has tripped (Reset button has
popped out). Press and release RESET (listen for click; Reset
button will latch and on some devices, a green light will turn
on) to resume operation.
A household fuse has blown, or circuit breaker has
tripped.
Replace the fuse or reset the circuit breaker. If the
problem continues, call an electrician. See "Electrical
Requirements."
The Power button has not been pressed. Press POWER.
The local power has failed. Wait for power to be restored.
Air conditioner
blows fuses or trips circuit breakers
Too many appliances are being used on the same circuit.
Unplug or relocate appliances that share the same circuit.
Time-delay
fuse or circuit breaker of the wrong capacity
is being used. Replace with a time-delay fuse or circuit
breaker of the correct capacity. See "Electrical
Requirements."
An extension cord is being used. Do not use an extension
cord with this or any other appliance.
You are trying to restart the air conditioner
too soon after
turning
off the air conditioner.
Wait at least 3 minutes after
turning off the air conditioner
before trying to restart the air
conditioner.
18

Advertisement

Table of Contents
loading

This manual is also suitable for:

W7wcc105xb0W7wcc128xb0

Table of Contents