Traffic Control - D-Link DGS-3312SR Product Manual

To configure a mirror port:
•
Select the Source Unit containing the port that is being mirrored.
•
Configure how the port is to be mirrored by selecting the direction that will be mirrored. Choose Ingress,
Egress, or Both for the mirrored port by clicking the appropriate radio button for the port.
•
Select the Target Port using the Unit and Port drop-down menus.
•
Change the Status drop-down menu to Enabled.
•
Click Apply to let the changes take effect.

Traffic Control

Use the Traffic Control Setting window to enable or disable storm control and adjust the threshold for multicast and
broadcast storms, as well as DLF (Destination Look Up Failure). Traffic control settings are applied to individual Switch
modules.
DGS-3312SR Gigabit Layer 3 Switch
Figure 4- 6. Setup Port Mirroring window
NOTE: You cannot mirror a fast port onto a slower port. For example, if you try
to mirror the traffic from a 100 Mbps port onto a 10 Mbps port, this can cause
throughput problems. The port you are copying frames from should always
support an equal or lower speed than the port to which you are sending the copies.
Also, the target port for the mirroring cannot be a member of a trunk group.
Please note a target port and a source port cannot be the same port.
43