D-Link DGS-3312SR Product Manual page 99

Configure the Access Rule Configuration settings on the window above.
The following parameters can be set:
Parameter
Profile ID
Mode
Access ID
Type
Priority(0-7)
Replace Priority(0-7)
DGS-3312SR Gigabit Layer 3 Switch
Figure 4- 53. Access Rule Configuration (Ethernet) window
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 to
255.
Select profile based on Ethernet (MAC Address), IP address or packet content mask.
This will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each
•
packet header.
Select IP to instruct the Switch to examine the IP address in each frame's
•
header.
Select Packet Content Mask to specify a mask to hide the content of the
•
packet header.
Specify the priority tag, located in the packet header that will be identified by the
Switch.
This parameter is specified if you want to change the 802.1p user priority of a packet
that meets the specified criteria. Otherwise, a packet will have its incoming 802.1p
86