D-Link DGS-3312SR Product Manual page 193

Select the desired Switch using the Unit drop-down menu and the desired port using the Port drop-down menu. The Time
Interval field sets the interval at which the error statistics are updated.
The following field can be set:
Parameter
Unit
Port
Clear
View Table
View Line Chart
64
65-127
128-255
256-511
512-1023
DGS-3312SR Gigabit Layer 3 Switch
Figure 8- 17. Packet Size Analysis (table) window
Description
Allows you to specify a Switch in a Switch stack using that Switch's Unit ID. 15
indicates a Switch in standalone mode.
Allows you to specify a port to monitor − from the Switch selected above.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Clicking this button instructs the Switch to display a line graph rather than a table.
The total number of packets (including bad packets) received that were 64 octets in
length (excluding framing bits but including FCS octets).
The total number of packets (including bad packets) received that were between 65
and 127 octets in length inclusive (excluding framing bits but including FCS octets).
The total number of packets (including bad packets) received that were between 128
and 255 octets in length inclusive (excluding framing bits but including FCS octets).
The total number of packets (including bad packets) received that were between 256
and 511 octets in length inclusive (excluding framing bits but including FCS octets).
The total number of packets (including bad packets) received that were between 512
and 1023 octets in length inclusive (excluding framing bits but including FCS octets).
180