Pim - D-Link DGS-3312SR Product Manual

Parameter
Interface Name<System>
IP Address
Probe Interval <10>
Neighbor Timeout Interval
<35>
Metric <1>
State <Disabled>

PIM

For a description of how Protocol Independent Multicast-Dense Mode (PIM-DM) functions, please read Appendix C.
The PIM-DM settings links are located in the PIM subfolder located in the Layer 3 IP Networking folder.
PIM-DM Global Setting
To use PIM-DM on the Switch it must be enabled globally. Use the PIM-DM Global Setting window to enable or disable
PIM-DM globally. Disabling PIM-DM will not affect any PIM-DM settings that have been configured so it can later be
enabled and apply the same settings.
Select Enabled or Disabled and click on the Apply button to make the change.
PIM-DM Interface Settings
PIM-DM settings can be configured on the Switch for existing IP interfaces. Each IP interface configured on the Switch is
displayed in the PIM-DM Interface Settings window. To configure an IP interface click on the hyperlinked Interface
Name:
DGS-3312SR Gigabit Layer 3 Switch
Description
Displays the name of the IP interface for which DVMRP is to be configured.
This must be a previously defined IP interface.
Displays the IP address corresponding to the IP Interface name entered
above.
This field allows an entry between 0 and 65,535 seconds and defines the
interval between 'probes'. The default is 10.
This field allows an entry between 1 and 65,535 seconds and defines the time
period for DVMRP will hold Neighbor Router reports before issuing poison
route messages. The default is 35 seconds.
This field allows an entry between 1 and 31 and defines the route cost for the
IP interface. The DVMRP route cost is a relative number that represents the
real cost of using this route in the construction of a multicast delivery tree. It is
similar to, but not defined as, the hop count in RIP. The default cost is 1.
This field can be toggled between Enabled and Disabled and enables or
disables DVMRP for the IP interface. The default is Disabled.
Figure 5- 53. PIM-DM Global Setting window
st
Figure 5- 54. 1 PIM-DM Interface Settings window
132