Lacp Port Settings - D-Link DGS-3312SR Product Manual

Type
Master Port
Member Unit
Port Map
Flooding Port
Active Port

LACP Port Settings

The LACP Port Mode Setup window is used in conjunction with the Link Aggregation windows to create port trunking
groups on the Switch. Using the following window, the user may set which ports will be active and passive in processing
and sending LACP control frames.
The user may set the following parameters:
DGS-3312SR Gigabit Layer 3 Switch
This pull-down menu allows you to select between Static and LACP (Link
Aggregation Control Protocol.) LACP allows for the automatic detection of links in a
Port Trunking Group.
Choose the Master port for the trunk group.
Choose the Switch unit on which to set up a trunk group. Trunk groups must be
confined to ports on a single Switch.
Choose the members of the trunked group. Up to eight ports per group can be
assigned to a group.
A trunking group must designate one port to allow transmission of broadcasts and
unknown unicasts.
Shows the port that is currently forwarding packets.
Figure 4- 10. LACP Port Mode Table window
46