Ospf Host Route Settings; Dhcp/Bootp Relay - D-Link DGS-3312SR Product Manual

OSPF Host Route Settings

OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with other OSPF routers.
This is used to work around problems that might prevent OSPF information sharing between routers.
To configure OSPF host routes, click the OSPF Host Route Settings link. To add a new OSPF Route, click the Add
button. Configure the setting in the menu that appears. The Add and Modify windows for OSPF host route setting are
nearly identical. The difference being that if you are changing an existing configuration you will be unable to change the
Host Address. To change an existing configuration, click on the hyperlinked Host Address in the list for the configuration
you want to change and proceed to change the metric or area ID. To eliminate an existing configuration, click the X in the
Delete column for the configuration being removed.
Use the window below to set up OSPF host routes.
Specify the host route settings and click the Apply button to add or change the settings. The new settings will appear listed
in the OSPF Host Route Settings window. To view the previous window, click the Show All OSPF Host Route Entries
link to return to the previous window.
The following fields are configured for OSPF host route:
Parameter
Host Address
Metric
Area ID

DHCP/Bootp Relay

Use DHCP/BOOTP configuration to allow the Switch to relay DHCP/BOOTP information packets to hosts that request
them from sources outside the interface on which they reside.
DGS-3312SR Gigabit Layer 3 Switch
Figure 5- 38. OSPF Host Route Settings window
Figure 5- 39. OSPF Host Route Settings – Add window
Description
The IP address of the OSPF host.
A value between 1 and 65,535 that will be advertised for the route.
A 32-bit number in the form of an IP ad dress (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
121