Kenmore 385.19153 Owner's Manual page 3

IMPORTANT
INSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use.
Read all instructions before using this sewing machine.
DANGER
-re reduce the nsk of electric shock:
1. A sewing machine should never be left unattended when plugged in. Always
unplug this sewing machine from the electric outlet immediately after using and
before cleaning.
2. Always unplug before replacing sewing machine bulb. Replace bulb with same
type rated 13.2 V d.c., 3 Watts,
3. Do not reach for a sewing machine that has fatlen into water. Unplug
immediately.
4. Do not place or store sewing machine where it can fall or be pulled into a tub or
sink. Do not place or drop into water or other liquid.
WARNING
-To reduce the risk of burns, fire, electric shock, or
iniury to persons:
1. Do not allow to be used as a toy. CIose attention as necessary when this sewing
machine Js used by or near children.
2. Use thJs sewing machine only for its intended use as described in this manual.
Use only attachments recommended by the manufacturer as contained in this
manual.
3. Never operate this sewing machine if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
Return the sewing machine to the nearest authonzed dealer or service center for
examination, repair, eiectncai or mechanical adjustment.
4,
5,
6.
7,
9.
10.
!1.
12.
13.
14.
15.
Never operate the sewtng machine with any air opening blocked, Keep ventilation
open=rigs of the sewing machine and foot controller free from accumulation of
lint, dust, and loose cloth.
Never drop or insert any obiect into any opening.
Do not use outdoors.
Do not operate where aerosol (spray) products are being used or where
oxygen Is being administered,
To disconnect, turn all controls to the off ("0") position, then remove plug from
outlet.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Keep fingers away from all moving parts, Special care is required around the
sewing machine needle.
Always use the proper needle plate. The wrong plate can cause the needfe to
break,
Do not use bent needles,
Do not pull or push fabnc while stitching, It may deflect the needle causing it to
break.
Switch the sewing machine off ("0°') when making any adiustment in the
needle area, such as threading needle, changing needle, threading bobbin or
changing presser foot, and the like.
Always unplug the sewing machine from the electrical outlet when removing
covers, lubricating, or when making any other adiustments mentioned in the
instruction manual.
SAVE INSTRUCTIONS
_mWabhen using your sewing machine for the first few times, p_ace a waste i
/
nc under the presser foot and run the machine without thread for a few
]
inutes. Wipe away any oil which may have appeared.