Parts Replacement; Precautions Concerning Parts Replacement - Oki OKIPAGE24DX Maintenance Manual

3.

PARTS REPLACEMENT

In this section, the removing and installing procedure of assembly and unit in field are described.
Although this section describes the removing procedure, the installing procedure is basically to
conduct the removing one in reverse.
3.1

Precautions Concerning Parts Replacement

(1) Parts replacements must be carried out, by first turning the printer power switch off "O" and
removing the High Capacity Second / Third Paper Feeder from the printer.
(2) Do not disassemble the Second/Third Paper Feeder if it is operating normally.
(3) Establish the extent of disassembly suitable for the purpose of the procedure, and do not
disassemble any more than necessary.
(4) Only specified service tools may be used.
(5) Disassembly must be carried out according to the prescribed procedures. Parts may be
damaged if such procedures are not followed.
(6) Small parts such as screws and collars can easily be lost, therefore these parts should be
temporarily fixed in the original location.
(7) When handling printed circuit boards, do not use any glove which may generate static
electricity.
(8) Do not place the printed circuit boards directly on the equipment or floor.
40930701TH DRAFT Vesion
195 /