Oki OKIPAGE24DX Maintenance Manual page 107

Category LCD status message
Daily status
READY
STACKER FULL
REMOVE THE PAPER
ATTENTION
READY
PAPER OUT
mmmmmmmmmm tttttt
ATTENTION
READY
tttttt INSTALL
ATTENTION
READY
mmmmmmmmm tttttt
PAPER REQUEST
ATTENTION
READY
ERROR POSTSCRIPT
ATTENTION
READY
ERROR MEMORY
OVERFLOW
ATTENTION
Trouble or status
Indicates that the face down stacker is full with sheets.
Indicates that no paper or paper cassette in a tray.
IIndicates that, in an attempt to use the third tray, the first or second
tray which is the medium of the path is pulled out.
Indicates that, in an attempt to use the second tray, the first tray which
is the medium of the path is pulled out.
Provisions: The first and second tray should be returned.
Requests that a sheet indicated in the first line message is inserted.
Indicates that the interpreter detects an error due to the following
reasons. From this point on, the receiving data is flushed until the
completion of a job. It is automatically canceled when job receiving is
completed.
Indicates that the capacity of memory is Overflowed due to the
following reasons. The operation is continued by pressing Recover
switch. Additional RAM should be installed or the amount of data be
reduced.
-Too large printing data within one page.
-Too large macro data.
-Too large DLL data.
-Overflow after the compression of frame buffer.
Remedy
Remove the paper from the stacker.
Repair the broker stacker sensor cable.
Repeat the insertion and removal of the connector.
Clean or replace the stacker full sensor.
Load a paper or paper cassette to the tray.
Install the displayed tray.
Load the requested paper in tray.
Warnig.
Check the print job format.
Press the RECOVER key on the operator panel to release
the error display.
Install an expansion optional RAM or reduce the amount of
print data.