8
Message cannot be received through the parallel interface.
•
Is the parallel I/F ENABLE in "HOST I/F" item of Menu 1.
•
No
•
Yes
•
Yes
•
No
•
Is the printer recovered?
•
YES END
•
No
•
No
•
Yes
•
Yes
•
No
40930701TH DRAFT Vesion
Set the Parallel I/F to "ENABLE".
Is the host set to the bidirectional communication?
Set the parallel I/F to the bidirectional communication enable state (DISABLE
ENABLE) in menu level 2.
Set the parallel I/F to the bidirectional communication disable state (ENABLE
DISABLE) in menu level 2.
Is the connector of the parallel interface cable connected to the printer prop-
erly?
Connect the connector of the parallel interface cable to the printer properly.
Is there any defect in the cable (broken or bent pin, broken wire)?
Replace the parallel interface cable.
Replace the Main board or ask the user to check the hardware and software at
the host side.
151 /