Oki OKIPAGE24DX Maintenance Manual page 111

Category LCD READY
message LED
Controller Light off
ERROR CONTROLLER
error nn-aaaaaaaa
Trouble or status
ATTENTION
LED
Flash A fault occurred in the printer.
Turn the power off, then on to release the error display. If the error
display cannot be released by this procedure, call a service person.
Code
(nn)
10 An error was detected by program hash check.
20 An error was detected by font format check.
30 An error was detected by resident RAM check.
40 An error was detected by EEPROM check.
50 An error was detected by optional software ROM.
60 An error was detected by optional RAM check.
70 A fault occurred in the fan motor.
Error
– Replace the program ROM.
(Location: BOARD-FFF: IC6, IC8, IC30, IC31)
– Replace the Main board (BOARD-FFF).
Note: When replacing the Main board, install the
– Replace the font ROM.
(Location: BOARD-FFF: IC6, IC8, IC30, IC31)
– Replace the Main board (BOARD-FFF).
Note: When replacing the Main board, install the
– Replace the Main board (BOARD-FFF).
Note: When replacing the Main board, install the
– Replace the EEPROM. (Location: IC19)
– Replace the Main board (BOARD-FFF).
– Replace the PostScript module (BOARD-MSM or
BOARD-FSL).
– Check the optional RAM for proper connection.
– Replace the optional RAM.
– Connect the fan motor cable properly.
– Replace the fan motor.
– Power Supply Unit (AC120V/ 230V)
Remedy
Remedy
EEPROM mounted on the replaced Main board.
EEPROM mounted on the replaced Main board.
EEPROM mounted on the replaced Main board.