Supported Peripheral Devices - Nortel CALLPILOT Installation And Configuration Manual

Part 2: 703t server hardware installation
Hide thumbs Also See for CALLPILOT:
Table of Contents

Advertisement

703t server description

Supported peripheral devices

Introduction
This section identifies external devices that are supported by the 703t
server. The following table describes the supported peripheral devices:
Device
Modem
Ethernet hub
28
Description
A 56 Kbps external modem (NTRH9078 in North
America only) provides remote access to the 703t server.
The modem connects to the RS-232 COM1 connector on
the rear of the server.
Since the modem is an external device, it requires its own
AC power source referenced to the same ground as the
703t server and the switch to which it is connected.
A 10Base-T Ethernet hub provides the ELAN connection
between the 703t server and the Meridian 1 switch or
Succession 1000 system. The customer can supply a hub
from third-party vendors or purchase the 3Com
10Base-T Ethernet hub (NTRH9017) from Nortel
Networks.
Since the hub is an external device, it requires an AC
power source referenced to the same ground as the 703t
server and the switch to which it is connected.
ATTENTION
If a hub is required or used, it must be located at least 6
m (20 ft) away from the 703t server. This ensures
compliance with EMC requirements.
Standard 1.01
CallPilot

Advertisement

Table of Contents
loading

This manual is also suitable for:

Callpilot 703t

Table of Contents