Nortel CALLPILOT Installation And Configuration Manual page 38

Preinstallation requirements
The following diagram shows how to remove the side panel. See the
instructions for removal below.
1 Place the server on its side on your working surface.
2 Turn the two thumbscrews on the back of the server counter-clockwise to
loosen them.
Note: The thumbscrews are not removable.
Note: If a removable screw is present, remove it. This screw secures the
cover to the server during shipping.
3 Place your fingertips in the depression on the side cover, and then as
you apply pressure, pull the cover approximately 2.5 cm (1 in.) away from
the front of the server until it stops.
38
1
2
3
Standard 1.01
G101761
CallPilot